Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 10:53 03 Jul 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : 4.6b21 and b25 verify error

     Page 2 of 2    
Author Message
jimbotron
Regular Member

Joined: 27/11/2013
Location: Australia
Posts: 50
Posted: 01:08am 03 Dec 2014
Copy link to clipboard 
Print this post

Do'h. Thanks for the correction John. That was embarrassing .
I presume that when it does auto-verification, that the chip is not allowed to run, which is why you don't get an error when programming.
Thanks for the explanation Geoff.
Glad you can get a signal to us. I'm going on 10 day cruise in about a week. Will be bringing my Micromite in a matchbox in case I get withdrawal symptoms.
Jimmy
 
bigmik

Guru

Joined: 20/06/2011
Location: Australia
Posts: 2949
Posted: 03:50pm 03 Dec 2014
Copy link to clipboard 
Print this post

Thanks Jimmy and Geoff,

It now makes sense and takes a load off my mind..

I cannot believe that I am the only person who did a manual verify after a successful burn.. Not that I ever had any issues at all with the verify (always a 100% burn) until I recieved the b21 and b25 images.

Anyway I now know I can still verify by changing 1 setting and that there is no problem with my programming setup.

Thanks all for your efforts in digging through this one.

Mick

Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<<
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025