Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 20:50 09 Nov 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : SPI2 weird open/close error.....

Author Message
Grogster

Admin Group

Joined: 31/12/2012
Location: New Zealand
Posts: 9748
Posted: 02:26am 21 May 2016
Copy link to clipboard 
Print this post

Geoff, what do you make of this?



Smoke makes things work. When the smoke gets out, it stops!
 
robert.rozee
Guru

Joined: 31/12/2012
Location: New Zealand
Posts: 2461
Posted: 02:33am 21 May 2016
Copy link to clipboard 
Print this post

"MMBasic Ver 5.1 Beta 3"

ummm, shouldn't you be using the release (non-beta) version of 5.1? or the 5.2 beta?

cheers,
rob :-)
 
Grogster

Admin Group

Joined: 31/12/2012
Location: New Zealand
Posts: 9748
Posted: 02:38am 21 May 2016
Copy link to clipboard 
Print this post

Excrement, that's a point.
Latest I have here is 5.2 B2 for the MM+.

It would not hurt to flash the new one in, so I will do that and see if that cures the problem.

EDIT: Nope.



Edited by Grogster 2016-05-22
Smoke makes things work. When the smoke gets out, it stops!
 
matherp
Guru

Joined: 11/12/2012
Location: United Kingdom
Posts: 10565
Posted: 03:49am 21 May 2016
Copy link to clipboard 
Print this post

Do you have an option lcdpanel set? You can't use spi2 from Basic if you have - see advanced features manual page 11. My Cfunctions use it through the backdoor. See the other thread for three working variants
 
Geoffg

Guru

Joined: 06/06/2011
Location: Australia
Posts: 3308
Posted: 04:21am 21 May 2016
Copy link to clipboard 
Print this post

Configuring the touch or the SD card will also make SPI2 unavailable.

Geoff
Geoff Graham - http://geoffg.net
 
robert.rozee
Guru

Joined: 31/12/2012
Location: New Zealand
Posts: 2461
Posted: 06:50am 21 May 2016
Copy link to clipboard 
Print this post

geoff: would it be possible to change the error messages to something like "Error: SPI2 unavailable"? and similar error messages could be used for attempts to use or configure other pins that have been reserved by the MMbasic interpreter.


cheers,
rob :-)

Edited by robert.rozee 2016-05-22
 
Geoffg

Guru

Joined: 06/06/2011
Location: Australia
Posts: 3308
Posted: 11:16am 21 May 2016
Copy link to clipboard 
Print this post

Yes, good point.
Geoff Graham - http://geoffg.net
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025