Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 02:34 08 Jul 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Maximite Serial Baud Rate

Author Message
hitsware
Guru

Joined: 23/11/2012
Location: United States
Posts: 535
Posted: 02:01pm 28 Jul 2016
Copy link to clipboard 
Print this post

I have just found that in BBCBasic
( even though the manual gives the standard
baud rates ( as does the MMBasic manual ))
I can write :

port% = OPENUP("COM1: 31250,N,8,1")

and instruct a Midi device.
I had always thought deviating from the
given rates would error some way.
Will the Maximite do the same ?
If so I could put the Midi device in
the 'Sea of Holes' and have a slick unit :)
 
TassyJim

Guru

Joined: 07/08/2011
Location: Australia
Posts: 6269
Posted: 02:11pm 28 Jul 2016
Copy link to clipboard 
Print this post

The Duinomite can on com3 and com4
I think the Maximite is restricted to the standard rates.
The micromites can use the SerialTx Cfunction which will do any baud rate up to a max limit.

Jim
VK7JH
MMedit
 
hitsware
Guru

Joined: 23/11/2012
Location: United States
Posts: 535
Posted: 04:56am 29 Jul 2016
Copy link to clipboard 
Print this post

Thank You Jim,
Yea, I remember the DuinoMite doing it now.
It might be better, since I could change 'shields'
(and synths) at whim.
I had one once but trashed it when the SD card holder
broke ..............
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025