Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 02:37 08 Jul 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : WARNING: using SDcard slots on displays

Author Message
matherp
Guru

Joined: 11/12/2012
Location: United Kingdom
Posts: 10222
Posted: 10:37pm 29 Jul 2016
Copy link to clipboard 
Print this post

If you are using the MM+ SDcard functionality or my SDcard drivers for the MM2 and are using the SDcard slot on a TFT display you should either:

set up OPTION TOUCH correctly for your wiring or
Set the pin connected to the chip select for the touch controller as an output and set it high. If you don't have a connection to the touch controller chip select add one!

If you don't do one of these there is a significant chance that with the touch chip select floating the touch controller will corrupt the SDcard SPI transactions. It will also corrupt ILI9341 transactions using my enhanced driver that reads from the display memory.

I've just wasted 4-hours on this
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025