TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 09:07 07 Jul 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Reading SD card.

Page 3 of 3

Author

Message

Phil23
Guru

Joined: 27/03/2016
Location: Australia
Posts: 1667

Posted: 01:12pm 30 Aug 2016

Copy link to clipboard

Print this post

WhiteWizzard said

WhiteWizzard said One question, is the SD card / Touch issue occurring on either SD socket, or only on one socket?

Any clues here?

Have tried both with the same result.

Different Options to accommodate the CD signal.

I know replacing it will probably solve the issue, but I sorta like answers & I don't mind taking a closer look.

I do have this:-

If I can get some advice on what to monitor I could look at a few pins when the OPEN command is issued.

Presume it's a case of when to trigger it, (off which pin) and roughly what rate to sample at;

and which pins to monitor.

It is specifically at that point that the touch is lost.

Grogster

Admin Group

Joined: 31/12/2012
Location: New Zealand
Posts: 9589

Posted: 07:22pm 30 Aug 2016

Copy link to clipboard

Print this post

@ Phil23 - I used to use that bottled flux - every night for twenty years, and I remember it seemed to work well.....

Smoke makes things work. When the smoke gets out, it stops!

palcal

Guru

Joined: 12/10/2011
Location: Australia
Posts: 1982

Posted: 10:38pm 30 Aug 2016

Copy link to clipboard

Print this post

@ Phil23
Did you get my PM
Paul.

"It is better to be ignorant and ask a stupid question than to be plain Stupid and not ask at all"

Phil23
Guru

Joined: 27/03/2016
Location: Australia
Posts: 1667

Posted: 03:53pm 31 Aug 2016

Copy link to clipboard

Print this post

palcal said @ Phil23
Did you get my PM
Paul.

Yes replied this morning.

Too many interruptions in this place.

Phil

Page 3 of 3

Print this page

To reply to this topic, you need to log in.