 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : New OLED I2C Display
| Author | Message | ||||
bigmik Guru  Joined: 20/06/2011 Location: AustraliaPosts: 2949 |
GDay All, Very busy time for me, hence being a bit quiet for a while, working 70+ hrs per week at the moment..At least lots of overtime to buy new toys.. Anyway I saw this little OLED 128x32 display module and thought it might be of interest to somebody.. It is sized so it could mount inside small packages. 0'91" OLED 128 x 64   Anyway hope it is of interest to someone... See you all in about 3-4 weeks when my work load drops off again. Kind Regards, Mick EDIT *** The drivers that PeterM wrote for the square OLED should work. See the information in this directory for my SERIAL BACKPACK Mik Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<< |
||||
CircuitGizmos Guru Joined: 08/09/2011 Location: United StatesPosts: 1427 |
Smaaallll. I ordered one to play with. Micromites and Maximites! - Beginning Maximite |
||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
