 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : E100 Console to CON8
| Author | Message | ||||
| Phil23 Guru  Joined: 27/03/2016 Location: AustraliaPosts: 1667 |
Just wondering if I can wire the console output to Con8 on the E100? More specifically, but basically paralleling it with Com3? Could use Click 1 (Con4) to connect Pin 25 to 87 & Pin 26 to 89. Would it work as long as I didn't open Com3 or assign pins 25 & 26? Or any of the other click board pins for that matter. Just got an ESP8266 & a HC-12 on the proto board connected to Con8 via a flat ribbon, but also need the console there, which is 2 loose wires. Thanks Phil. |
||||
Geoffg Guru Joined: 06/06/2011 Location: AustraliaPosts: 3308 |
Yes, it would work. Geoff Graham - http://geoffg.net |
||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
