Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 08:14 10 Nov 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Fonts

Author Message
vk4cuz
Newbie

Joined: 10/08/2017
Location: Australia
Posts: 4
Posted: 10:09pm 09 Aug 2017
Copy link to clipboard 
Print this post

Hi all,
Using MM+ LCD backpack, and various programs.
Firmware v5.04.05
Had running the clock program for a trial. This overwrites some of the fonts installed.
Went back to try something else with the GUI's. Had an issue with the fonts in the Gui Numberbox. Letters were oversized.
Deleted the fonts in the library.
Now the Gui Numberbox doesn't display anything sensible at all.

Is there a way to restore the MM+ to original or do I have to reflash the MM+.

Gary
 
Geoffg

Guru

Joined: 06/06/2011
Location: Australia
Posts: 3308
Posted: 10:27pm 09 Aug 2017
Copy link to clipboard 
Print this post

  vk4cuz said  Is there a way to restore the MM+ to original

LIBRARY DELETE and NEW should clear everything in program memory.
or
Send a stream of exclamation marks (!) to the console Rx pin at 38400 baud while powering up the Micromite. This will reset everything including options. See page 16 of the Micromite User Manual.

Geoff
Geoff Graham - http://geoffg.net
 
vk4cuz
Newbie

Joined: 10/08/2017
Location: Australia
Posts: 4
Posted: 10:37pm 09 Aug 2017
Copy link to clipboard 
Print this post

Thanks Geoff

Library delete and New did not work.

Full reset worked. Fonts now displaying correctly in numberbox.

Gary
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025