Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 14:19 10 Nov 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : CMM IR problem

Author Message
antf70
Newbie

Joined: 13/07/2016
Location: Australia
Posts: 20
Posted: 11:06pm 01 Nov 2017
Copy link to clipboard 
Print this post

Hi All,
Is there a problem with IR interrupts when CHAINing programs on CMM firmware v4.5?
 
Geoffg

Guru

Joined: 06/06/2011
Location: Australia
Posts: 3308
Posted: 03:22am 02 Nov 2017
Copy link to clipboard 
Print this post

I have not tested this but there could easily be an issue. Looking at the source the CHAIN command disables interrupts on I/O pins but not the IR interrupt. So you should specifically use IR CLOSE before invoking CHAIN.

Geoff
Geoff Graham - http://geoffg.net
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025