Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.
|
Forum Index : Microcontroller and PC projects : Micromite Display
Author | Message | ||||
Fang_Bolt Newbie Joined: 07/10/2019 Location: IrelandPosts: 3 |
After programming display ,the touch control is mirrored. Any ideas anyone ? |
||||
lizby Guru Joined: 17/05/2016 Location: United StatesPosts: 3010 |
More information needed. Which micromite, which display, which backpack or other additional PCB (if any). What does "the touch control is mirrored" mean? PicoMite, Armmite F4, SensorKits, MMBasic Hardware, Games, etc. on fruitoftheshed |
||||
Geoffg Guru Joined: 06/06/2011 Location: AustraliaPosts: 3165 |
Probably you loaded a HEX file from my site which contained MMBasic + config options + BASIC program. The calibration of the touch was done with a reasonably "standard" LCD panel but your panel is different from my panel. The solution is simple. Attach a USB/Serial converter to the console. Interrupt the running program with CTRL-C and re do the touch calibration using GUI CALIBRATE. Geoff Geoff Graham - http://geoffg.net |
||||
Fang_Bolt Newbie Joined: 07/10/2019 Location: IrelandPosts: 3 |
Many Thamks |
||||
Fang_Bolt Newbie Joined: 07/10/2019 Location: IrelandPosts: 3 |
Many Thamks |
||||
Print this page |