Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 19:51 16 Nov 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Kindly request for EDITOR

Author Message
jirsoft

Guru

Joined: 18/09/2020
Location: Czech Republic
Posts: 533
Posted: 11:50am 06 Dec 2020
Copy link to clipboard 
Print this post

Hi Peter,
could be in EDITOR added shift + TAB to move line with cursor left for TAB-characters and maybe shift + DEL to remove indentation at all? I'm most of the time indent and un-indent my code when I move some parts from and to SUBs/FUNCTIONs; and this could be big help.

Also when ENTER goes not to begin of new line but to last indent position, that will be just perfect...
Jiri
Napoleon Commander and SimplEd for CMM2 (GitHub),  CMM2.fun
 
matherp
Guru

Joined: 11/12/2012
Location: United Kingdom
Posts: 10589
Posted: 02:22pm 06 Dec 2020
Copy link to clipboard 
Print this post

Try downloading RC3 again
 
jirsoft

Guru

Joined: 18/09/2020
Location: Czech Republic
Posts: 533
Posted: 04:35pm 06 Dec 2020
Copy link to clipboard 
Print this post

Thanks Peter,
very BIG improvement!
Jiri
Napoleon Commander and SimplEd for CMM2 (GitHub),  CMM2.fun
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025