Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 08:40 20 Nov 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Help please with WinPIC

Author Message
larny
Guru

Joined: 31/10/2011
Location: Australia
Posts: 348
Posted: 01:14am 22 Jan 2022
Copy link to clipboard 
Print this post

I followed the instructs given by Wolfgang Buescher & added the PIC16F1708 to WinPIC. When I programmed a 1708, WinPIC stated that the programming had failed. The message said "0x008005 read 0x002005 wanted 0x003FFF". But the HEX code was green rather than red, so I tested the PIC & it worked except that RB5 (defined as an input) did not work. So I re-opened WinPIC & looked at the Config memory tab (see the first attachment). It indicates that location 0x8005 is 0x3FFF. So why did the message claim it read 0x2005? I then opened devices.ini (see second attachment) but could not find anything regarding 0x8005. Wolfgang's instruction did not mention this issue as far as I could determine. I bought a PICKit3 some years ago but it eventually failed & destroyed a 12F675. So I bought another PK3 & it worked for while, but when I recently attempted to programme a 16F1708, it destroyed the PIC. So I don't wish to buy any more PK3. Any assistance will be appreciated.
WinPIC info.pdf
 
Mixtel90

Guru

Joined: 05/10/2019
Location: United Kingdom
Posts: 8298
Posted: 08:02am 22 Jan 2022
Copy link to clipboard 
Print this post

Sorry, larny, I've payed with PICs but not with WinPIC so I can't help with that.

Interesting problems with your PICKit3s though. I've never had problems with either my official PICKit2 or my super el-cheapo ebay PICKit3 copy. I must admit I've not used a 16F1708 though, but plenty of 12F675s. Just wondering if the programmer is treating a 16LF1708 as a 16F1708 and putting 5V on instead of 3V3.
Mick

Zilog Inside! nascom.info for Nascom & Gemini
Preliminary MMBasic docs & my PCB designs
 
Tinine
Guru

Joined: 30/03/2016
Location: United Kingdom
Posts: 1646
Posted: 03:18pm 22 Jan 2022
Copy link to clipboard 
Print this post

I had a PK3 clone based on a positive review...it was garbage; reported successful programming when it wasn't even physically connected  

Went with the official PK4 and never an issue.

Craig
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025