Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.
|
Forum Index : Microcontroller and PC projects : WTB Printed Panels
Author | Message | ||||
toml_12953 Guru Joined: 13/02/2015 Location: United StatesPosts: 323 |
Does anyone sell printed front/rear panels for the Gen 2 CMM? If so where can I get them? I'm looking for two sets if possible. I'm in the USA but don't care if it costs a bit to have them shipped. Thanks for your time! |
||||
twofingers Guru Joined: 02/06/2014 Location: GermanyPosts: 1124 |
Hi, I guess something like this will not help? There should be more (DIY) in July 2020 (2020-07-28_143342_CMM2-case.zip). Regards Michael |
||||
mclout999 Guru Joined: 05/07/2020 Location: United StatesPosts: 430 |
https://geoffg.net/maximite.html The main project list some vendors, but for your convenience from that page. Rictech in New Zealand supply the design illustrated above: https://www.rictech.nz/micromite-products Some suppliers have created their own designs which offer some additional features but are still compatible with the Generation 2 design and runs the same firmware. These are: CircuitGizmos in the USA https://circuitgizmos.com/RetroMax-CGs-Color-Maximite-2-p241231864 PS Labs in Poland https://sklep.pslabs.pl/Maximite-c91/s_lang/en Are there any more now! |
||||
toml_12953 Guru Joined: 13/02/2015 Location: United StatesPosts: 323 |
I just ordered two sets from Rictech. Thanks for the tip! |
||||
Print this page |