Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 15:17 04 Dec 2022 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : CMM2: Manual Error - Nunchuk function

Author Message
Turbo46

Guru

Joined: 24/12/2017
Location: Australia
Posts: 1120
Posted: 12:13am 14 Nov 2022
Copy link to clipboard 
Print this post

Sometime after CMM2 MMBasic V5.06.00 the Nunchuk function description in the manual changed from:

NUNCHUK(funct [, channel])
to:
NUNCHUK(channel, funct)

This appears to be wrong. As the manual says, the channel is optional and if omitted it will default to channel 3 which is the one used for the front connector on the original CMM2.

The CMM2 does not accept the second version of the command.

Bill
Keep safe. Live long and prosper.
 
Turbo46

Guru

Joined: 24/12/2017
Location: Australia
Posts: 1120
Posted: 10:58pm 16 Nov 2022
Copy link to clipboard 
Print this post

Found more problems in the CMM2 manual.

The CALL function is missing from the bookmarks although the description is there.

Between the MEMORY and MID$ command bookmarks there are a couple of misplaced bookmarks which take you to the middle of a description.

Bill
Keep safe. Live long and prosper.
 
thwill

Guru

Joined: 16/09/2019
Location: United Kingdom
Posts: 2830
Posted: 10:25am 18 Nov 2022
Copy link to clipboard 
Print this post

Additional CMM2 manual issues:

- the description of the CLASSIC() function says "T returns the ID code of the controller - should be hex &H4200101" ... that's incorrect it is hex &HA4200101.

- MEMORY COPY and MEMORY SET are undocumented.

Best wishes,

Tom
Edited 2022-11-18 20:25 by thwill
CMM2 Welcome Tape, Creaky old text adventures
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2022