Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.
|
Forum Index : Microcontroller and PC projects : PORT command/function
Page 2 of 2 | |||||
Author | Message | ||||
Volhout Guru Joined: 05/03/2018 Location: NetherlandsPosts: 3519 |
Yip, I noticed the same... Apparently if you use GP numbers it skips GND pins automatically. It does not skip gnd pins when using numbers. a = port(gp0,6) works a = port(1,6) does not work.... Volhout Edited 2022-12-03 00:57 by Volhout PicomiteVGA PETSCII ROBOTS |
||||
Tinine Guru Joined: 30/03/2016 Location: United KingdomPosts: 1646 |
Suits me as I use gp exclusively. Crazy how GND pins are even a thing |
||||
Page 2 of 2 |
Print this page |