Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 09:01 11 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : For Jim ref Crunch & ON ERROR SKIP [nn]

Author Message
Chopperp

Guru

Joined: 03/01/2018
Location: Australia
Posts: 1090
Posted: 12:03am 22 May 2023
Copy link to clipboard 
Print this post

Hi Jim

Question regarding  "Crunch" in MM Edit & Command "ON ERROR SKIP [nn]"

I assume it is the responsibility of the programmer to ensure that there are no commented lines within the range of the SKIP[nn] number if using Crunch?

May need a warning somewhere if there isn't already one.

Still on V5.0.5

Thanks for MM Edit.

Brian
ChopperP
 
TassyJim

Guru

Joined: 07/08/2011
Location: Australia
Posts: 6220
Posted: 12:33am 22 May 2023
Copy link to clipboard 
Print this post

What device are you programming for?
As far as I can remember, SKIP skips over commands, not lines and comments inserted in the skip zone make no difference.

I rarely use SKIP for anything other than one command at a time so haven't had much experience with it doing the unexpected.

I think there was an issue with user defined SUBs and what to skip over but I don't remember which platform it involved.

Jim
VK7JH
MMedit
 
Chopperp

Guru

Joined: 03/01/2018
Location: Australia
Posts: 1090
Posted: 12:40am 22 May 2023
Copy link to clipboard 
Print this post

Hi Jim

OK, misread the instructions. Sorry

Using it when opening files on an F4 as it sometimes cracks a hissy-fit. Need to skip to after the Close # command if it plays up.

Will count commands rather than lines.

Thanks

Brian
ChopperP
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025