Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 21:11 12 Jul 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Old Pico W with new Image

Author Message
Dinosaur

Guru

Joined: 12/08/2011
Location: Australia
Posts: 338
Posted: 08:39pm 30 Dec 2024
Copy link to clipboard 
Print this post

Hi All

I have not been following the extensive work carried out on the latest Pico Image as I usually only use the Zero W 2.

However as a matter of interest I tried loading V6.00.01 into a two year old Pico and it failed.

The Pico is marked as "Pico W 2022" and on the underside "IC:20953-PicoW"

When I clear the flash and copy in an older Image "WebMiteV5.07.08RC17" it's all ok.
When I load "WebmiteRP2040V6.00.01" it finished copying and then does not reboot.
Resetting the power does not resolve it.

Is there something obvious I am missing ?

Regards
Regards
Hervey Bay Qld.
 
disco4now

Guru

Joined: 18/12/2014
Location: Australia
Posts: 1000
Posted: 09:16pm 30 Dec 2024
Copy link to clipboard 
Print this post

There was an issue with the download initially, just download again as its been refreshed. I have same board and now starts with the refreshed WebmiteRP2040V6.00.01
Latest F4 Latest H7 FotS
 
Dinosaur

Guru

Joined: 12/08/2011
Location: Australia
Posts: 338
Posted: 09:34pm 30 Dec 2024
Copy link to clipboard 
Print this post

Hi All

Thanks for that.
I had done that before, but this time a phone call interrupted me and when I finished
it was actually fired up.

Perhaps it takes longer to boot than with previous images and I just got impatient.
Regards
Hervey Bay Qld.
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025