 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : MMEdit V5.3.4
  Page 3 of 3 |
|||||
| Author | Message | ||||
| Volhout Guru  Joined: 05/03/2018 Location: NetherlandsPosts: 5446 |
No, this was on linux (Ubuntu 20.04). And it was the "previous" 5.3.6 build, not today's one (I understand that that is only an update to MMCC). Volhout (I also have a system running Ubuntu 24.04 at home, and I will take this evening to load MMedit 5.3.6 on it and confirm, since it currently has 5.3.3). I hope my issue is not due compatibility between current MMedit builds and the "old" linux 20.04, since 20.04 has always been very reliable for me. Edited 2025-11-06 20:50 by Volhout PicomiteVGA PETSCII ROBOTS |
||||
TassyJim Guru Joined: 07/08/2011 Location: AustraliaPosts: 6353 |
Thanks for that. I can rule out any funny Windows thing that's the cause. That leaves me as the problem. My Linux VM is 20.4 but I have recently loaded 24.04 on a spare PC. This enabled me to fix the serial port issue and a few other things. The test MMCC was compiled on that PC but I have gone back to the VM so I will stay with a combination that I know works. Jim VK7JH MMedit |
||||
| Volhout Guru Joined: 05/03/2018 Location: NetherlandsPosts: 5446 |
@Jim, Tried all evening on 2 systems (ubuntu 20.04 and 24.04) could not reproduce the lockup. Sorry if I mislead you. Volhout PicomiteVGA PETSCII ROBOTS |
||||
| TassyJim Guru Joined: 07/08/2011 Location: AustraliaPosts: 6353 |
I can go for days without seeing a lockup. That is what makes it difficult to diagnose. If it happened once on Linux that IS something to consider. Jim VK7JH MMedit |
||||
| Page 3 of 3 |
|||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
