Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 18:44 19 Apr 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : hamfield board pwr supply

Author Message
sparkey

Senior Member

Joined: 15/06/2011
Location: Australia
Posts: 819
Posted: 05:38am 20 Aug 2011
Copy link to clipboard 
Print this post

short note if you r using one of the add on boards from hamfield that has three regs on it and are using the regs to their potential you will require a suppy of three amps
: :typically i recomend a two amp 14 volt generally the twelve volt reg should have three volts higher than its out put the 5volt and 3,3 volt should not be a problem as these regulators r capeable of a much higher input voltage but just rember ::its all about current::

:regards sparkey :: Edited by sparkey 2011-08-21
technicians do it with least resistance
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024