Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 07:33 05 May 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : MMBasic 4.0B ports

Author Message
vk4tec

Senior Member

Joined: 24/03/2012
Location: Australia
Posts: 239
Posted: 06:17pm 02 Jan 2013
Copy link to clipboard 
Print this post

Hello

I am re-visting an LCD/GPS setup.

My DuinoMite logger currently uses COM1 under MMBasic 4.0B

I have a clash, and I need to move to COM2

COM3 is still on the UEXT connector.

Geoff, et all, can you confirm please that COM2 is PIN(19)IN and PIN(20)OUT

Anyone had better results with ribbon cable ?

I have the grey stuff and its pretty fragile. ( wire is pretty thin )

I got the CRO out and found these :





- Andrew -
Edited by vk4tec 2013-01-04
Andrew Rich VK4TEC
www.tech-software.net
 
vk4tec

Senior Member

Joined: 24/03/2012
Location: Australia
Posts: 239
Posted: 01:04am 03 Jan 2013
Copy link to clipboard 
Print this post

Here is a graphic of my connections



- Andrew -
Andrew Rich VK4TEC
www.tech-software.net
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024