Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 06:55 05 May 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Hacking Altronics Mains Remote Control

Author Message
Ray B
Senior Member

Joined: 16/02/2007
Location: Australia
Posts: 219
Posted: 02:14am 07 Jan 2013
Copy link to clipboard 
Print this post

For several years I've been using a couple of the Altronics Mains Remote Control Switches around the house that provides 8 channels & runs at the usual 433 MHz. Cost for controller and one remote is less than A$20.
http://www.altronics.com.au/index.asp?area=item&id=A0340

Started looking at hacking the code to extend the range & found this link where it has already been done as follows for an Arduino but then the code will be similar for other controllers:
http://www.smithonline.id.au/?Greg:Wireless_Control

Enjoy

RayB from Perth WA
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024