Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 16:23 27 Apr 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Step motors

Author Message
ztoti
Regular Member

Joined: 27/10/2011
Location: Canada
Posts: 65
Posted: 04:59am 22 Apr 2013
Copy link to clipboard 
Print this post

Hi there,
I uploaded to youtube a project with Maximite/Duinomite, any comment are welcome.
http://www.youtube.com/watch?v=FaJEpP7EbNU
Thanks
 
paceman
Guru

Joined: 07/10/2011
Location: Australia
Posts: 1326
Posted: 04:51pm 23 Apr 2013
Copy link to clipboard 
Print this post

Hi ztoti,
What are you using it for/developing - or are you just testing?
 
StoveMan
Regular Member

Joined: 29/03/2013
Location: United States
Posts: 51
Posted: 05:36am 29 Apr 2013
Copy link to clipboard 
Print this post

ztoti:
NICE! The menu and display screens are no small feat in themselves. Wondering how you are talking to the steppers. Is the MM sending step and direction and keeping count locally? Or are you using a higher level driver/translator and sending position and speed commands from MM?
From the sound and speed of the motors in the video the pulses are faster than what I would imagine MM could do in a loop (unless you are using hardware PWM?); but I see a real time position feedback on the graphed pattern run which looks local? Very tricky!
Have you tried coordinated motion with you setup?
How many lines are you running on MMbasic?
Nice project! Frank
 
ztoti
Regular Member

Joined: 27/10/2011
Location: Canada
Posts: 65
Posted: 07:19pm 05 May 2013
Copy link to clipboard 
Print this post

Hello,
This project is for medicine - it's use to testing on small animal, fixed on the "bed" (animal is a live don't worry :).
I'm using a step motor with driver and controller on it - intelegent one. All step motors are connected through RS485 to Duinomite (with Maximite Basic4.x) and I do communication with one serial port to all motors.
Thank you for watching.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024