Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.
|
Forum Index : Microcontroller and PC projects : 4.6b21 and b25 verify error
Page 2 of 2 | |||||
Author | Message | ||||
jimbotron Regular Member Joined: 27/11/2013 Location: AustraliaPosts: 46 |
Do'h. Thanks for the correction John. That was embarrassing . I presume that when it does auto-verification, that the chip is not allowed to run, which is why you don't get an error when programming. Thanks for the explanation Geoff. Glad you can get a signal to us. I'm going on 10 day cruise in about a week. Will be bringing my Micromite in a matchbox in case I get withdrawal symptoms. Jimmy |
||||
bigmik Guru Joined: 20/06/2011 Location: AustraliaPosts: 2870 |
Thanks Jimmy and Geoff, It now makes sense and takes a load off my mind.. I cannot believe that I am the only person who did a manual verify after a successful burn.. Not that I ever had any issues at all with the verify (always a 100% burn) until I recieved the b21 and b25 images. Anyway I now know I can still verify by changing 1 setting and that there is no problem with my programming setup. Thanks all for your efforts in digging through this one. Mick Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<< |
||||
Page 2 of 2 |
Print this page |