 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : Help - Programming ASCII Terminal
  Page 2 of 2 |
|||||
| Author | Message | ||||
Grogster Admin Group  Joined: 31/12/2012 Location: New ZealandPosts: 9082 |
Well done - glad it is now working. 
Yes, that Vcap is mission-critical. It MUST be a good quality tantalum, or an X5R SMD ceramic, if you are designing for SMD. It would seem that the PIC32 core intensely dislikes bog-standard caps, which is probably a good thing anyway!  Smoke makes things work. When the smoke gets out, it stops! |
||||
bigmik Guru  Joined: 20/06/2011 Location: AustraliaPosts: 2870 |
Hi Steve, Glad it is all working for you.. I am fairly certain that firmware I sent is OK to use as I copied it out of a 250 that was flashed with v1.0 then updated via USB to 1.2. I would use the one that has the bootloader as well when Geoff releases V1.2w B/Loader to be sure. Regards, Mick Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<< |
||||
Geoffg Guru Joined: 06/06/2011 Location: AustraliaPosts: 3167 |
I have finally got the latest firmware + bootloader out. Check this post if you have not seen it already: http://www.thebackshed.com/forum/forum_posts.asp?TID=7290&PN =1 Geoff Geoff Graham - http://geoffg.net |
||||
| Page 2 of 2 |
|||||
 Print this page |
