Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 07:13 04 Jul 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : I2C pullup voltage?

Author Message
Bizzie
Senior Member

Joined: 06/07/2014
Location: Australia
Posts: 192
Posted: 08:57pm 05 Jan 2015
Copy link to clipboard 
Print this post

I have a logging system which has been successfully working for nearly 3 years. It consists of a PicAxe 20X2 acting as the master scanning up to 5 PA 20X2's using I2C.

I would like to replace the master with a CGColorMax2 so I can get access to the data over the Internet and also be able to write the data to SD.

What voltage should I pull the two I2C signal lines to? The MM pins are 5V tolerant so I assume it would be 5 volts.

Rob White
 
TassyJim

Guru

Joined: 07/08/2011
Location: Australia
Posts: 6266
Posted: 09:01pm 05 Jan 2015
Copy link to clipboard 
Print this post

5V or 3.3V depending on the requirements of the other devices.

JimEdited by TassyJim 2015-01-07
VK7JH
MMedit
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025