Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.
|
Forum Index : Microcontroller and PC projects : Servo command on 4.7b23
Author | Message | ||||
sagt3k Guru Joined: 01/02/2015 Location: ItalyPosts: 313 |
Hi Geoff I use "servo" command on firmware 4.6 with no problems. In new version 4.7b23, Are there differences between these versions? Thanks |
||||
Geoffg Guru Joined: 06/06/2011 Location: AustraliaPosts: 3165 |
No, the commands are the same in both. But be aware that B23 is a test version and there may be bugs. Geoff Graham - http://geoffg.net |
||||
Print this page |