 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : SPI2 weird open/close error.....
| Author | Message | ||||
Grogster Admin Group  Joined: 31/12/2012 Location: New ZealandPosts: 9082 |
Geoff, what do you make of this? 
Smoke makes things work. When the smoke gets out, it stops! |
||||
| robert.rozee Guru  Joined: 31/12/2012 Location: New ZealandPosts: 2294 |
"MMBasic Ver 5.1 Beta 3" ummm, shouldn't you be using the release (non-beta) version of 5.1? or the 5.2 beta? cheers, rob :-) |
||||
| Grogster Admin Group Joined: 31/12/2012 Location: New ZealandPosts: 9082 |
Excrement, that's a point. Latest I have here is 5.2 B2 for the MM+. It would not hurt to flash the new one in, so I will do that and see if that cures the problem. EDIT: Nope. 
Smoke makes things work. When the smoke gets out, it stops! |
||||
| matherp Guru Joined: 11/12/2012 Location: United KingdomPosts: 8605 |
Do you have an option lcdpanel set? You can't use spi2 from Basic if you have - see advanced features manual page 11. My Cfunctions use it through the backdoor. See the other thread for three working variants |
||||
Geoffg Guru Joined: 06/06/2011 Location: AustraliaPosts: 3167 |
Configuring the touch or the SD card will also make SPI2 unavailable. Geoff Geoff Graham - http://geoffg.net |
||||
| robert.rozee Guru Joined: 31/12/2012 Location: New ZealandPosts: 2294 |
geoff: would it be possible to change the error messages to something like "Error: SPI2 unavailable"? and similar error messages could be used for attempts to use or configure other pins that have been reserved by the MMbasic interpreter. cheers, rob :-) |
||||
| Geoffg Guru Joined: 06/06/2011 Location: AustraliaPosts: 3167 |
Yes, good point. Geoff Graham - http://geoffg.net |
||||
 Print this page |
