Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 18:56 07 Jul 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : CGMICROBOARD2 Firmware Update.

Author Message
Phil23
Guru

Joined: 27/03/2016
Location: Australia
Posts: 1667
Posted: 11:20am 25 Jul 2016
Copy link to clipboard 
Print this post

Hi All,

Just wondering how to update the firmware on the CGMICROBOARD2.

I know there's no ICSP port, but I can't see how to connect the PicKit3.

[Code]Pin1 - MCLR - µM7
Pin2 - Vcc
Pin3 - Gnd
Pin4 - PGD - µM16
Pin5 - PGD - µM15[/code]

Can't see µM7 labelled on the pinouts.

Phil.
 
CircuitGizmos

Guru

Joined: 08/09/2011
Location: United States
Posts: 1427
Posted: 11:31am 25 Jul 2016
Copy link to clipboard 
Print this post

Pin1 - MCLR - Reset - right next to 3.3V
Micromites and Maximites! - Beginning Maximite
 
Phil23
Guru

Joined: 27/03/2016
Location: Australia
Posts: 1667
Posted: 11:36am 25 Jul 2016
Copy link to clipboard 
Print this post

Thanks,

Was just looking at the schematic in another tab & found it.
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025