Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 12:09 05 May 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : MMbasic 5.3 Requests.

     Page 11 of 11    
Author Message
retepsnikrep

Senior Member

Joined: 31/12/2007
Location: United Kingdom
Posts: 131
Posted: 07:41am 26 Apr 2017
Copy link to clipboard 
Print this post

Having had a look through the MMBasic source I can see the PIC internal pullup/down is being set to prevent the Com port RX pins from floating.

Could I ask that it be included as an option rather than mandatory in the next version of MMBasic for the Extreme 144.

I have external pull ups in my application due to fixed higher voltage hardware i'm talking with (5 & 12V).

In this situation the internal pull ups prevented me from using a simple series resistor and diode solution into the RX pin as described in the MMBasic manual.

Many Thanks..Edited by retepsnikrep 2017-04-27
Gen1 Honda Insights.
 
matherp
Guru

Joined: 11/12/2012
Location: United Kingdom
Posts: 8592
Posted: 08:15am 26 Apr 2017
Copy link to clipboard 
Print this post

The "weak" pullup on the PIC MX chips is roughly 66K (50uA @ 3.3V) and 82K (40uA @ 3.3V) on the MZ so there should be no issue in overcoming it to get below the low voltage threshold. Is your source already high impedance before the resistor/diode clamping?
 
retepsnikrep

Senior Member

Joined: 31/12/2007
Location: United Kingdom
Posts: 131
Posted: 08:43pm 26 Apr 2017
Copy link to clipboard 
Print this post

Peter I will try to keep it all in the other thread. i have replied on there.. Thanks
Gen1 Honda Insights.
 
     Page 11 of 11    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024