 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : OPTION VCC command ...
| Author | Message | ||||
sagt3k Guru  Joined: 01/02/2015 Location: ItalyPosts: 313 |
Hi Geoff and matherp I read in the MZ manual that there is a interesting "option" : OPTION VCC command Is it possibile to extend this option to Micromite and Micromite Plus versions? Thanks sagt3k |
||||
Geoffg Guru Joined: 06/06/2011 Location: AustraliaPosts: 3308 |
Actually Peter and I had a discussion on this. My view was that it is easy to scale the reading from the analogue input so you do not need yet another option. For example: V = (PIN(xx) / 3.3) * Vcc but Peter's view was that OPTION VCC was simpler and more logical... Geoff Geoff Graham - http://geoffg.net |
||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
