Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 06:46 05 May 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Raspberry Pi "Desktop"

Author Message
cdeagle
Senior Member

Joined: 22/06/2014
Location: United States
Posts: 261
Posted: 12:15pm 05 Jul 2017
Copy link to clipboard 
Print this post

A couple of pictures of the Raspberry Pi "desktop" that I'm using to check out MMBASIC code. The "stack" consists of a fan on top (5v power from GPIO), the Pi in the middle and a lithium power supply on the bottom pallet.

I use a wall wart most of the time to power the Pi and charge the battery. The battery allows "portable" use for a few hours. USB keyboard and mouse. Second "disk" using a 32GB USB drive.
 
Zonker

Guru

Joined: 18/08/2012
Location: United States
Posts: 761
Posted: 01:50pm 05 Jul 2017
Copy link to clipboard 
Print this post

Nice..!!
Good looking stack enclosure... Nice and "open"..

Attach the IDE cable and go... Did you do the plastic design..?
 
cdeagle
Senior Member

Joined: 22/06/2014
Location: United States
Posts: 261
Posted: 11:04pm 05 Jul 2017
Copy link to clipboard 
Print this post

Everything except the Pi was purchased as a kit of parts.
 
hitsware
Guru

Joined: 23/11/2012
Location: United States
Posts: 535
Posted: 08:35am 06 Jul 2017
Copy link to clipboard 
Print this post

Me too !
If I find I can print with a RPi , I'll try to convert my wife

 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024