 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : DOS on Win10-64bit
| Author | Message | ||||
| IanT Regular Member  Joined: 29/11/2016 Location: United KingdomPosts: 84 |
Sorry, Newbie request. I've looked through here for how folk with W10-64b are running MMBasic on DOS but haven't seen it mentioned. I know I need to use a 'virtual' DOS of some kind (vDOS?) but would appreciate any suggestions/recommendations as to what is best 'DOS' software to use when running MMBasic. Regards, IanT |
||||
TassyJim Guru  Joined: 07/08/2011 Location: AustraliaPosts: 5923 |
The 'DOS' version of MMBasic is a Win32 console application so it runs happily under W10 32 or 64 bit. It doesn't need any installation, just unzip and run it. Jim VK7JH MMedit  MMBasic Help |
||||
| IanT Regular Member Joined: 29/11/2016 Location: United KingdomPosts: 84 |
“Don’t build roadblocks out of assumptions.” Thank you Jim - I seem to have a habit of making things harder than they need to be. Regards, IanT |
||||
Grogster Admin Group  Joined: 31/12/2012 Location: New ZealandPosts: 9083 |
It's just you, me, and the rest of the world......   Smoke makes things work. When the smoke gets out, it stops! |
||||
 Print this page |
