Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 01:31 30 Mar 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : PCB Manufacturing : DiY PCB

Author Message
bigmik

Guru

Joined: 20/06/2011
Location: Australia
Posts: 2861
Posted: 01:58am 07 Feb 2019
Copy link to clipboard 
Print this post

Hi All,


I often watch Bigclive.com video clips for some technical based entertainment..

I have just watched this DiY Security light Clip and I was amazed at the method Clive used to create what I consider excellent PCBs.

The clip goes for about 43minutes but the PCB making is from about 6m30 to around the 18min mark..

Anyway I was quite impressed with this.

Kind Regards,

Mick
Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<<
 
Chopperp

Guru

Joined: 03/01/2018
Location: Australia
Posts: 1028
Posted: 01:04pm 09 Feb 2019
Copy link to clipboard 
Print this post

Certainly uses interesting methods. I'll need to watch the video a few more times to get used to his accent & try to understand what he says in places.

Good idea just using a smaller piece of the expensive film taped to a sheet of paper. I've done a similar thing with photo paper that won't pull through the printer.

Thanks.

Brian
ChopperP
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024