Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 16:45 01 Feb 2026 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : PCB Manufacturing : Trying for my first PCB

Author Message
calcmandan

Newbie

Joined: 24/07/2020
Location: United States
Posts: 12
Posted: 12:30pm 31 Jan 2026
Copy link to clipboard 
Print this post

I went to KLCPCB to get my first CMM2s made and ran into a complication with parts. I read through the BOM file and can't really distinguish how it differs. Can someone shed light? It says the footprint for this part doesn't match the BOM. I attached a screenshot.

Also, they're out of stock of the 75R resistors for R11,R22,R33. Supposedly it calls for twenty of these resistors though it only appears to only require, to me, six.

calcmandan
sysop  : air & wave bbs
finger  : calcmandan@bbs.erb.pw
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2026