 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Windmills : blade steem alighn
| Author | Message | ||||
| adelaide Regular Member  Joined: 24/03/2006 Location: AustraliaPosts: 46 |
hi has any 1 used steem on section of wood to corect a blade that changed after glued/screw ? 1 has angle bit out so want to steem a foot of it with paint sanded off and re do angle slightly, say with alfoil around it and steem out of steem cleener small 1 for 1/2 hour? help to make progres or radio and vitamin b |
||||
Gizmo Admin Group  Joined: 05/06/2004 Location: AustraliaPosts: 5148 |
I dont see why it would not work. I've bent balsa wood with steam. I sprayed the balsa with a water spray, then used a cloths iron on high to turn the water to steam and bend the balsa around a drum to get the curve I wanted. Worked real good. Glenn The best time to plant a tree was twenty years ago, the second best time is right now. JAQ |
||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
