TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 20:22 13 Aug 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Energy Collector?

Author

Message

WindtonSandino
Newbie

Joined: 16/11/2009
Location: Argentina
Posts: 6

Posted: 10:00pm 15 Nov 2009

Copy link to clipboard

Print this post

Hi! well, I have been wondering about the way in which I can collect the energy produced by my future windmill. That is to say, I don't know what device to use set wires between the windmill itself and the batteries without the wires being entangled (since the windmill is spinning with each wind direction change)

Thanks in advance!

Strange, but not a stranger.

KarlJ

Guru

Joined: 19/05/2008
Location: Australia
Posts: 1178

Posted: 06:34am 16 Nov 2009

Copy link to clipboard

Print this post

Two options drop wire with 15A extension cord, apparently handles the twists well. Can use the plugs to disconnect and reconnect for un-twisting.
or
slip rings
see Trev for an off the shelf solution on the site.

Luck favours the well prepared

Print this page

To reply to this topic, you need to log in.