Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 11:44 06 Nov 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Got a little TV time

Author Message
Dupa

Newbie

Joined: 09/12/2009
Location: United States
Posts: 27
Posted: 03:03pm 15 Dec 2009
Copy link to clipboard 
Print this post

Well the local TV channel did a little ditty on my wind turbine set up. My 15seconds of fame.

http://www.wzzm13.com/news/news_story.aspx?storyid=116683&ca tid=14 http://www.wzzm13.com/news/news_story.aspx?storyid=116683&ca tid=14Edited by Dupa 2009-12-17
I is a injenear
 
cobo351
Newbie

Joined: 18/12/2009
Location: United States
Posts: 34
Posted: 03:35am 18 Dec 2009
Copy link to clipboard 
Print this post

i noticed that your wind turbines wasn't turning.
 
cobo351
Newbie

Joined: 18/12/2009
Location: United States
Posts: 34
Posted: 03:41am 18 Dec 2009
Copy link to clipboard 
Print this post

good story though.
 
MacGyver

Guru

Joined: 12/05/2009
Location: United States
Posts: 1329
Posted: 04:26am 18 Dec 2009
Copy link to clipboard 
Print this post

How cool is that?
Good job!
Nothing difficult is ever easy!
Perhaps better stated in the words of Morgan Freeman,
"Where there is no struggle, there is no progress!"
Copeville, Texas
 
JimBo911

Senior Member

Joined: 26/03/2009
Location: United States
Posts: 262
Posted: 04:45am 19 Dec 2009
Copy link to clipboard 
Print this post

That's very cool.
It's great to be able to show off your stuff!

Job well done.
Jim
 
Dupa

Newbie

Joined: 09/12/2009
Location: United States
Posts: 27
Posted: 01:45pm 19 Dec 2009
Copy link to clipboard 
Print this post

Thanks for the compliments guy's.
You may see me on the news again when Oceana county try’s to slam me with all kinds of unreasonable permit requirements.
I is a injenear
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025