TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 09:40 16 Aug 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : F&P Combos

Author

Message

readyakira

Senior Member

Joined: 17/07/2008
Location: United States
Posts: 114

Posted: 05:49pm 07 Jan 2010

Copy link to clipboard

Print this post

I am doing a 7phase conversion on my 42 pole, but am going to have some 36poles left. Is there a wiring combo that makes the 36 work with the other mag hub?

Don't you think Free/Renewable energy should be mandatory in new buildings?

KarlJ

Guru

Joined: 19/05/2008
Location: Australia
Posts: 1178

Posted: 03:03am 10 Jan 2010

Copy link to clipboard

Print this post

one of the smart cookies might be able to come up with something, my tip strip them for SCRAP.

no offense to the guys from the USA using the 60S from Randys workshop as the postage is prohibitive at $160 each.. from me but unless you have a VAWT and need low running speed voltage, I think the 80S is a more flexible piece of kit,
spectacularly time consuming rewiring the 36S as 12X1C for the lower voltages , add delta to the mix and you'd be an old man by the time you were done.

Your 7phase should work well at 24V and can be less expensive than the cap voltage doubler.....that said you would need some experimenting and more caps to do a doubler for 7phases instead of three.

Luck favours the well prepared

Print this page

To reply to this topic, you need to log in.