TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 22:24 16 Aug 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : F&P distributers

Author

Message

Quail
Newbie

Joined: 16/02/2010
Location: United States
Posts: 2

Posted: 09:25pm 15 Feb 2010

Copy link to clipboard

Print this post

I have not been able to get a hold of Randy from www.randysworkshop.com to see if he has any F&P motors left. Does any one else know a USA source for the motors at a cost comparable to Randy's?

KarlJ

Guru

Joined: 19/05/2008
Location: Australia
Posts: 1178

Posted: 05:28am 16 Feb 2010

Copy link to clipboard

Print this post

Motors from Me with shaft and Hub are
$50 plus $160 in freight!

if you like I have a 60S decogged and an 80 S rewired as 2x7P 1/2 star 1/2 delta remaining from the 30 I had.
Being USA you can have both, the bearing block (which randy doesnt have) and the shaft for $50 +post which is going to be about $180.

Bearings are good for 3m rotor and having 2 stators will give you a better range of output (hence matching to prop) not to mention almost double the output.

I wish I had another solution.

Karl

Luck favours the well prepared

Print this page

To reply to this topic, you need to log in.