Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 22:47 18 Aug 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Hubs for PVC and Ali Blades

Author Message
old mate's mate

Newbie

Joined: 11/08/2010
Location: Australia
Posts: 15
Posted: 06:45am 19 Aug 2010
Copy link to clipboard 
Print this post

Fellow enthusiasts, greetings .....

I have just priced getting some F&P hubs for the extruded blades laser cut as per the dxf on this site. A single set (at 6mm) * 5 components was quoted at approx $160.00. If I order 10 of each economies of scale kick in and they are cheaper.

I can't use 10 sets, would anybody else be interested in a set at around $75.00 plus postage ?

If there is enough interest I will organise the work and postage. Please reply if interested. If I proceed with the order it should take about 2 weeks to deliver to you.

PS I tried getting them cut with a plasma cutter but it looks like the concentrated heat while cutting the splines ruined the job, has anybody else had a similar experience ? As with everything there a probably a few flavours of plasma cutters out there ......

all good (7 phase 3*2C rewire of the F&P successful !!)

OMM

 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025