TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 00:40 13 May 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : F&P coil coating

Author

Message

chriso38
Newbie

Joined: 16/05/2011
Location: Australia
Posts: 2

Posted: 05:15am 29 Sep 2011

Copy link to clipboard

Print this post

Hi all

just rewired a F&P smart drive, and can anyone tell me what can i coat the soldered wires in to stop corrosion? thanks

Gizmo

Admin Group

Joined: 05/06/2004
Location: Australia
Posts: 5111

Posted: 05:52am 29 Sep 2011

Copy link to clipboard

Print this post

I would just paint the whole stator with clear outdoor furniture varnish. It soaks into the coils and laminations very well.

I think any outdoor paint would do. The laminations do rust, so should be painted, but not too thick as there isn't much gap between them and the magnets.

Glenn

The best time to plant a tree was twenty years ago, the second best time is right now.
JAQ

BobMann

Senior Member

Joined: 30/06/2011
Location: United States
Posts: 134

Posted: 12:17pm 29 Sep 2011

Copy link to clipboard

Print this post

Hello I have found the right product to do this job Red Insulating Varnish
GC Electronics PT# 10-9002-A I to spray the whole stator with clear coat as a back up.
Bob Mann

Tinker

Guru

Joined: 07/11/2007
Location: Australia
Posts: 1904

Posted: 03:18pm 29 Sep 2011

Copy link to clipboard

Print this post

If its just the soldered joints you want to coat then a product called "liquid electrical tape" does the trick. Its available from places like Super Cheap or chandlers.

Klaus

Print this page

To reply to this topic, you need to log in.