TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 23:16 07 May 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : wiring? Mini mill battery charger

Author

Message

AlSpong
Newbie

Joined: 03/03/2012
Location: Australia
Posts: 4

Posted: 03:02pm 03 Mar 2012

Copy link to clipboard

Print this post

Hi,
i set out to make the mini mill battery charger as my first ever wind powered project, but i have come up short. The problem is that reading electrical diagrams is not my strong point - in particular the diagram that shows the wiring coming from the stepper motor.
Could anyone please point in me in the right direction. I need either a laymans explanation of this, or a book that can explain wiring diagrams like this simply. I am mechanically very able, but these diagrams i find difficult.
Thanks Alistair

Bub73

Senior Member

Joined: 10/12/2009
Location: United States
Posts: 116

Posted: 04:38pm 03 Mar 2012

Copy link to clipboard

Print this post

I found this on the net back when I first started, maybe it will help.
Most stepper motors are 2 phase with a center tap of some sort.

Bob

AlSpong
Newbie

Joined: 03/03/2012
Location: Australia
Posts: 4

Posted: 07:53am 12 Mar 2012

Copy link to clipboard

Print this post

Thanks,
that little positive sign made all the difference, not sure if it was on the website diagrams,
thanks Alistair

Print this page

To reply to this topic, you need to log in.