 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Windmills : Connecting Windturbine Direct to Inverter
| Author | Message | ||||
Jaffasoft Senior Member  Joined: 03/11/2010 Location: AustraliaPosts: 102 |
Can i run a Windturbine direct to a 12v 2500Watt Inverter to test the mill? And dump any load buy leaving the Inverter switched on and plugging a 240v light globe or a heater in to dump the load straight in there? I have the other proper equipment such as to charge batteries and 10,000watt 440 amp with a dump load control box, just havent been able to afford a fuse and a 12v 500 watt dump to heat water up with yet. |
||||
Gizmo Admin Group  Joined: 05/06/2004 Location: AustraliaPosts: 5110 |
Hi Jaffasoft Is there going to be a battery in this circuit? Your typical inverter has a input voltage range that it will function within. Too high or too low and the inverter will set of an alarm and shut down. A windmill supplies a wildly changing output voltage, so a battery is needed to dampen down the voltage changes. But other than that, I dont see why you couldn't load up the inverter output to help control the charging of the supply battery. Just keep a close eye on it. You should still include some way to shut down the windmill electrically or mechanically. Glenn The best time to plant a tree was twenty years ago, the second best time is right now. JAQ |
||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
