![]() |
Forum Index : Windmills : F&P issue
Author | Message | ||||
rippleephex Newbie ![]() Joined: 20/05/2012 Location: AustraliaPosts: 2 |
Hi All, I'm having an issue with my F&P Generator. i have wired it so that it is in the star configuration and have the 3 phase cables running to a rectifier. The issue i'm having is that on the 3 phase side of the rectifier i'm getting 18+ volts easily when spun by hand, however on the DC side of the rectifier i'm barely getting 1 volt. I have tried 2 rectifiers and both have the same issue. any ideas? this is my first wind generator :) Thanks |
||||
Gizmo![]() Admin Group ![]() Joined: 05/06/2004 Location: AustraliaPosts: 5108 |
Are you setting your meter to read DC volts on the rectifier output? Glenn The best time to plant a tree was twenty years ago, the second best time is right now. JAQ |
||||
rippleephex Newbie ![]() Joined: 20/05/2012 Location: AustraliaPosts: 2 |
Hi Glenn, Thanks for you help. That was the issue, i have used this multimeter a lot for car radios and a few other things, i just got the settings mixed up :S thanks again! much appreciated! Heath |
||||
![]() |
![]() |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |