Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 16:14 19 Jun 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Using SEEK

Author Message
Chrisk

Senior Member

Joined: 21/12/2014
Location: Australia
Posts: 118
Posted: 08:34am 25 Mar 2023
Copy link to clipboard 
Print this post

Hi all

I am trying to print some lines from a file using the seek command.
I can get it to print from the start of the file using forward.bas but I really want it to print from the bottom up.
I have tried manipulating with the value "y" but keep getting an error.
Any ideas?


ps
I found that this program runs forward in the old version of MMBasic but not in the latest.

Chrisk


forward.zip


Looks like it went to Windmills instead of Microprocessors
Edited 2023-03-26 11:41 by Chrisk
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024