Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 13:19 02 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Programming PIC MX250

Author Message
palcal

Guru

Joined: 12/10/2011
Location: Australia
Posts: 1959
Posted: 10:19pm 03 Oct 2024
Copy link to clipboard 
Print this post

I have always had trouble using my PicKit3 programmer getting it to connect. I bought an MPLAB Snap but when I try to connect I get the message
"You have entered an invalid value (null) for the Voltage Level on the Snap Power property page." Wherever that is.No idea what that means.
I don't think this would work but for the MX170s I program them in circuit via the 1455 using the PicProg gui. If I put the MX250 in a 170 board will it program.
"It is better to be ignorant and ask a stupid question than to be plain Stupid and not ask at all"
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025