TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 11:24 16 Aug 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : chinese 300w 24 to small grid unit

Author

Message

rgormley
Senior Member

Joined: 22/02/2006
Location: Australia
Posts: 245

Posted: 01:49am 15 Jan 2010

Copy link to clipboard

Print this post

How would this grid tie unit go on a jaycar chinese 300watt mill? mill is 24v output

http://cgi.ebay.com.au/300W-GRID-TIE-POWER-INVERTER-solar-pa nel-wind-turbine_W0QQitemZ300348621786QQcmdZViewItemQQptZAU_ Boat_Parts_Accessories?hash=item45ee2c43da

i`m converned about "sync" times before it outputs power back to the grid as the mill output is very eratic

also, would my 3.6kw fronius get unhappy about some other device trying to sync to the mains?
as in see the other smaller grid tie unit playing on the mains and not be able to sync or worse... smoke??

Cheers,
Richard

KarlJ

Guru

Joined: 19/05/2008
Location: Australia
Posts: 1178

Posted: 02:00am 15 Jan 2010

Copy link to clipboard

Print this post

The chines mill will smoke it is the general consensus here.

You will need some form of overvoltage protection.

Luck favours the well prepared

Print this page

To reply to this topic, you need to log in.