Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 13:26 17 May 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Off topic archive. : Goodbye for now maybe for good

     Page 2 of 2    
Author Message
Dinges
Senior Member

Joined: 04/01/2008
Location: Albania
Posts: 510
Posted: 12:18am 27 Nov 2008
Copy link to clipboard 
Print this post

Seems that using imperial sized magnets (2"x1"x.5") should work fine too. The ridge between the magnets becomes thin (1.1mm), but with my 10hp rotor it was even smaller, .75mm, and that didn't pose any problems in machining either.

Anyway, below are the finished sketches for 2x1x.5" magnets. I think all critical dimensions are included.

Peter.








 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024