Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.
|
Forum Index : Off topic archive. : Cheap reading lamp
Author | Message | ||||
vasi Guru Joined: 23/03/2007 Location: RomaniaPosts: 1697 |
I bought a few reading lamps, made in China. It have 8 LED's and all are soldered in parallel. The wires are connected via a switch to 3x AA sized batteries. So, LED's are connected to 4.5V and I think is too much. I like these lamps and I want to make them resist longer. I think a 56R resistor will do the job. Or maybe 1k resistor if I want to use a LM7805 to connect them to a 12V system. These lamps I think can be found also in Australia. Any experience of using them? Hobbit name: Togo Toadfoot of Frogmorton Elvish name: Mablung Miriel Beyound Arduino Lang |
||||
woofnumber0 Newbie Joined: 26/04/2008 Location: United KingdomPosts: 10 |
Hi tryed simlar ones out of the pound shop,pen lights with 3 led connect to the usb ,6volt took the pen out wired them in seris,stuck another stem in the pen hole,from another light.Great if u stick them through your cap,for walking down to the pub on dark nights or as a night light outside your cabin fully ajustable both stems.ps speeling is my week point |
||||
Print this page |