Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 03:27 04 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Electronics : F & P Smart Drive motor

Author Message
bill_gill85
Newbie

Joined: 22/05/2007
Location:
Posts: 3
Posted: 01:04am 22 May 2007
Copy link to clipboard 
Print this post

Hi,

I am placing an entry into an electric vehicle challenge & was wondering about the suitability of using a F&P motor as a hub motor (driven as a 36V stepper motor). Has anyone tried this & is it suitable?
 
Gizmo

Admin Group

Joined: 05/06/2004
Location: Australia
Posts: 5107
Posted: 01:28am 22 May 2007
Copy link to clipboard 
Print this post

Yes I have tried it. See http://www.thebackshed.com/mackaysolarcar/index.html
We gave up on the idea after several month trying. Problems with the mosfets blowing. The mosfets work in a 3 phase H bridge configuration, the high side driver is a fiddly beast.
But I think it could be done, we just ran out of time.

Glenn

The best time to plant a tree was twenty years ago, the second best time is right now.
JAQ
 
dwyer
Guru

Joined: 19/09/2005
Location: Australia
Posts: 574
Posted: 09:35am 22 May 2007
Copy link to clipboard 
Print this post

Hi gimzo
Do you have any Schematic drawing for using a F&P motor specility low voltage 12 to 36 ??
Thank

Dwyer
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025